the expert in intruder-resistant walls
Are you looking for intruder-resistant walls?
To secure an entire building, perhaps, or to provide an important room within a building with additional protection against intrusion? Then you need look no further than aalbers|wico - the specialist in structural intruder security. We manufacture, supply and install intruder-resistant walls precisely in accordance with your specifications. If you wish, they can also be offered in combination with ballistic-, blast- and fire-resistant properties.
tested by ‘intruders’
The resistance value of our walls has not only been calculated on paper – it has been tested in practice too. At our own test centre we can see how our walls stand up to the toughest of challenges. Using a range of tools, experienced ‘intruders’ test various aspects of a wall’s resistance, in accordance with the applicable division into resistance classes.
Our walls are based on standards such as NEN 5096, EN 1627-1630, EN 356 and ISO 16936, but we can also go one step further. If stipulated in the Schedule of Requirements, we can supply a wall offering the actual level of resistance you need. The official standards form the starting point here, but the wall undergoes further testing on the basis of additional criteria.
Find out more about standards for intruder-resistant walls in our knowledge centre
The standards in the area of intruder resistance require walls to be tested in three ways: with a static load, with a dynamic load and by means of manual intrusion tests.
Find out more about testing methods for intruder-resistant walls in our knowledge centre
In the case of manual tests, the resistance class of an intruder-resistant wall is defined on the basis of two factors: the time the ‘intruder’ takes to force his way through the wall and the tools that may be used for this purpose. The longer the time taken and the heavier the tools, the higher the resistance class.
Find out more about resistance classes for intruder-resistant walls in our knowledge centre